Pole lighting · 2026
B25-0620 AOA Gate 348 Construction
DFW Airport, TX · near Dallas-Fort Worth Intl (1.7 mi)
What this outcome means
The FAA sent the case back to the filer rather than issuing a determination. This is the most common non-clean outcome and usually means something has to change or be supplied before the study can finish — not that the project was refused.
The proposal, in the filer's words
"B25-0620 AOA Gate 348 Construction\nScope will require infrastructure to support Emergency Entrance System proposed camera and pole wireless connectivity.\nThis gate will have the Emergency Entrance System\nSecurity Data will be carried on cellular signal via Cellular Gateway provided by DFW.\nAOA fencing will be temporally relocated to allow for construction on public side of gate. Temporary fencing will remain throughout duration of construction. Gate\nwill be functional during construction due to emergency vehicle traffic. With the SIDA line temporally relocated all work will be performed on public side.\nBefore trenching contractor to call 811 FAA Fiber and Power Locate Jet Fuel located ATMOS Gas locate and all other utilities.\nInfrastructure scope requires concrete saw cutting and demolition on more secure side of gate. Trenching for conduit drilling or vacuum excavation of camera pole pier\nfoundation rough-in conduit inspections performed backfill trenches and take densities. Form and pour drive and pole pier foundation. Pole placed on pier\nfoundation. Camera placed on pole. All trenching to he by hand vacuum or mini excavator.\nConduit installed under concrete shall be Sch 80. Conduit installed in grass area shall be Sch 40 covered in flow-fill concrete.\nTallest piece of equipment at any time during construction is 21’\nInfrastructure scope requires the following:\nConstruction of (1) Concrete pier foundation 4500 PSI Strength\nSetting of a camera pole. Max height of pole and all components equal 22.7 feet.\nHoffman 14 gauge type 316L cabinet on pole\nTAB to install Hanwha PNM-C16083RVQ camera\nDFW to install Wireless Gateway manufactured by Teltonika including cabling\nDFW to perform FT4 Testing"
Filing details
- Case number (ASN)
- 2026-ASW-779-NRA
- Structure
- B25-0620 AOA Gate 348 Construction
- Type
- Pole
- Category
- Pole lighting
- Height above ground
- 25 ft
- Height above sea level
- 588 ft
- Site elevation
- 563 ft
- Notice of
- New Construction
- Duration
- Permanent
- Marking & lighting
- —
Timeline
- Filed
- February 11, 2026
- Determined
- April 8, 2026
- Determination expires
- October 8, 2027
A determination that lapses before the structure is built has to be re-filed. The FAA does not send a reminder.
Who filed it
- Sponsor
- DFW International Airport
- Representative
- DFW International Airport
Names are shown as they appear in the FAA's public record. How we handle names
Location
- Coordinates
- 32.888472, -97.064564
- Degrees / minutes / seconds
- 32°53'18.5"N 97°03'52.4"W
- County
- Tarrant
- Open in a map
- Google MapsOpenStreetMap
Other filings within 5 miles
Organisation-sponsored 2026 filings whose coordinates sit near this one.
See every 2026 filing near Dallas-Fort Worth Intl →
About this record
This page is a readable copy of a public record published by the FAA's Obstruction Evaluation / Airport Airspace Analysis system. It is not the official record and may lag it. For the authoritative case status, search this ASN at the FAA's OE/AAA portal. If something here is wrong, email support@idea-engine.studio and we will correct it.
Source: FAA Obstruction Evaluation / Airport Airspace Analysis (OE/AAA) public archive (oeaaa.faa.gov), data as of September 12, 2026. Compiled by LOS Analyzer (Idea Engine LLC). This is not an official FAA record or an FAA determination; the FAA's portal is authoritative. LOS Analyzer is not affiliated with or endorsed by the FAA.
Screening a structure of your own?
Check Part 77 and the tower's line of sight before you file
LOS Analyzer screens a proposed structure against FAA Part 77 surfaces and the control tower's sightline to the runway, terrain-aware, in minutes. It is a preliminary screening — not an FAA determination and not a substitute for a licensed engineering review.